KJT - T.441 - 11Y - UE - 243 Тяжелый ограничитель хода
- ● :2 cable entries M20
- ● :metal shell
- ● :106mm x 99mm x 63mm (basic assembly)
- ● :Класс защиты IP65
KJT heavy-duty limit switch is a mechanical control switch, which is used for conveyor belt deviation prevention, crane over-roll protection, and rope pull switch. Taking advantage of its high reliability, it is widely used in steel equipment, large conveying machinery, loading and unloading machinery and cement equipment. Resistant to harsh environments. The glass sealing joint is filled with inert gas
Product parameters | |
Модель | T.441-11Y-UE-243 |
Принцип действия | Машины |
Shell raw materials | Gray cast iron, galvanized |
Contact material | Серебро |
gross weight | 1,070g |
Normally closed quantity (NC) | 1 |
Normally open quantity (NO) | 1 |
B 10D normally closed contact (NC) | 2,000,000 operations |
operating units | plunger |
Механический срок службы | 10,000,000 operations |
Угол действия | 20° |
contact open circuit | 2×6mm |
Action direction | Rotate left and right 60° each time |
Minimum drive speed | 1mm/min |
Maximum action speed | 1m/sec |
Замечания | Action speed: Driving speed of the vertical drive angle switching axis |
Circuit connection | Screw connection M20 x 1.5 |
Minimum cable cross-section | 1.5mm² |
Maximum cable cross section | 2.5mm² |
Замечания | Cable part: including conductor ferrules |
Wire cross section | 13 AWG |
Product Size | |
length, width and height | 63mm*106mm*99mm |
Caster diameter | 25mm |
Plunger diameter | 10mm |
Lever length, width and height | 25mm*25mm*141mm |
Application environmental conditions | |
Класс защиты | МП65 |
Температура окружающей среды | -30 ... +90°C |
Rated insulation voltage | 400 VAC |
Rated impulse withstand voltage | 6kV |
Electrical data | |
Thermal test current | 16A |
Application categories | AC-15: 400 V / 4 A |
switching element | Normally open contact, normally closed contact |
Switching principle | slow motion |
Верхний и нижний уровни | 3,000/hour |
Precautions | |
Actuating from the side of the plunger should be avoided as this will shorten the mechanical life of the position switch. |